MEGATECH Software Upgrade for Controller Version 1
Begin by connecting a USB flashdrive to an available USB port on your Windows computer.
From the window below labeled “TRAFIX Upgrades” click on the link: “TRAFIX-1.10.0 Upgrade”
Save the file to your USB thumb drive. **If you receive a prompt asking if you’d like to overwrite the existing “upgrade.stu” file, click YES.
When finished, remove the USB flashdrive from your Windows computer.
Make sure that the voltage of the message board is above 12 VDC as indicated on the Energy Management System. Power down the Control Console.
Connect the USB flashdrive to the USB port at the rear of the MegaTech Control Console.
Power up the Control Console and allow it to boot.
The MegaTech Control Console software will detect the USB flashdrive and start the upgrade. You should see a display that indicates the progress of the upgrade followed by a display which indicates the status of the completed upgrade (Success or Error). Please allow up to twenty (20) minutes for the upgrade to complete. Do NOT power down while the upgrade is in progress.
When the upgrade is completed successfully, power down the Control Console and remove the USB flashdrive from the USB port.
Power up the MegaTech Control Console and allow it to boot normally. The system should now be running with the latest version of Control Console application software. Power down the MegaTech Control Console again and boot normally. Your upgrade is now complete.
In the event that you receive an “Error” message during the upgrade procedure, please contact the Customer Service Department of Solar Technology Inc. for further assistance at 1-800-475-5442.
**If your version is older than 1.8.2 please contact Customer Service for assistance at 800-475-5442.
**TRAFIX 1.10.0 requires Control Center 3000 Version 1.9.0 (or later) to function properly. It is STRONGLY recommended that you update Control Center 3000 BEFORE manually updating TRAFIX on your PCMS units.**
Before downloading Control Center 3000 for the first time, please be sure to create a new folder on your computer and save the file to that location.
If you have an existing version of Control Center 3000 installed on your computer, please locate your Control Center 3000 folder and overwrite the old “.jar” file with the new downloaded “.jar” file. By overwriting only the “.jar” file all of your current data and settings will be maintained and your desktop icon will continue to function.